Table of Contents
Spaenaur Catalog 14 - Digital Flipping Catalog
CATALOG 14 H P : 1-800-265-8772 F : 1-888-252-6380 www. .com Inch Pouce Air Nozzles / Pneumatic Silencers H5 1/8" NPT 24 sec. 1/4" NPT 17.5 sec. 1/8" NPT 5.2 oz. 1/4" NPT 6.1 oz. High Thrust Air Nozzles Buses d’air à pression élevée Description High Thrust Air Nozzles are designed for low noise, high thrust, and maximum efficiency. Low compressed air use saves energy while producing extremely high thrust and back pressure. Outside air is entrained to the extent that the air output is more than 45 times the compressed air input . Noise is reduced as much as 25 dB (A) when compared to a 3 inch long open tube at 120 psi. All units are precision set at the factory and have no moving parts. Application Maximum efficiency is provided by Nozzles at pressures up to 150 psig, making them ideal for use in parts ejection conveying, drying, and cleaning operations. (Filter separators are necessary in lines where nozzles are used.) Aluminum construction is strong, yet lightweight, and affords corrosion resistance. 314-505 (1/8" NPT) Air Entrainment is more than 45 times compressed air input As expressed by exhaust time to reduce the pressure in a one cubic foot vessel from 100 psi to 20 psi through a wide open nozzle. Typical thrust as measured 8 inches from the nozzle on a 6 inch diameter target at 60 psi. SPAENAUR No. A B C D Weight 314-505 1/8" 11/16" 2-7/16" .7" 3/4 oz. THRUST C D A NPT B HEX — reduce noise — increase pressure BACK PRESSURE OUTSIDE AIR COMPRESSED AIR OUTSIDE AIR TOTAL AIR OUTPUT Available in Five Sizes SPAENAUR No. 314-500 314-501 314-502 314-503 314-504 Pneumatic Silencers Silencieux pneumatiques Reduce Air Noise ! Test Data Total discharge of 1 ft. tank (120 P.S.I. to 0 P.S.I.) NPT 3" Long Pipe Pneumatic Insertion Size dB(A) Silencer Loss dB(A) 1/8" 119 85 34 1/4" 120 85 35 3/8" 120 88 32 1/2" 118 80 38 Test Description D L PKG QTY. 1 19 JAN 2018 NPT Approximate Dia. Wt. Size L D Grams 1/8" 1-3/8" 3 1/4" 1-5/8" 5 3/8" 2-3/4" 10 1/2" 2-7/8" 12 3/4" 5-1/2" 5/8" 3/4" 1" 1" 1-1/2" 40 PKG QTY. 1 For discharge time and sound pressure level tests the silencers were attached to the end of a 1/2 inch diameter pipe, 6 inches long which was attached through a valve to a one cubic foot cylindrical air tank. The tank was charged to 120 P.S.I. and then by suddenly opening the valve was allowed to discharge through the silencer. Discharge time was measured using a stopwatch and was defined as the time for the tank back pressures to decrease from 100 P.S.I. to 20 P.S.I. Maximum A-weighted sound pressure levels and discharge times were recorded simultaneously for all tests. Insertion loss is the difference between the noise that is generated by the tank being exhausted through a three inch long pipe and through a silencer having the same NPT size. Pneumatic Air Silencers reduce air valve noise in a safe manner, and at a low cost. These silencers are made of Porex, a tough, high-density polyethylene. This porous material allows expanding air to escape at noise levels below OSHA standards, reducing air blast to a whisper. Safety is afforded by resilient plastic which will not shatter.Threaded base is made of solid, high-density polyethylene. Pneumatic Air Silencers can be used on any equipment discharging air. They operate at pressures up to 150 psi and are designed to fit most air valves. Silencers are easily cleaned with industrial cleaners, and are unaffected by water and oil usually present in air lines. Buses d'air / silencieux pneumatiques F : 1- 8-252-6380 service@spaenaur. © 2018 Spaenaur Inc. All rights reserved. Catalog may not be reproduced, in whole or in part, without the written permission of Spaenaur Inc. Subject to Catalog Terms and Conditions of Use available at Spaenaur.com and on page TC2 and TC3 at the back of this catalog. © 2018 Spaenaur Inc. Tous droits réservés. Le catalogue ne peut être reproduit, en tout ou en partie, sans l’autorisation écrite de Spaenaur Inc. L’utilisation est soumise aux Conditions d’utilisation du Catalogue disponibles sur Spaenaur.com et à la page TC4 et TC5 à la fin de ce catalogue.